Page 1 of 1
Throttle Boddy Driver
Posted: Sat Aug 28, 2021 3:32 pm
by rick
Been playing with a some Speeduinos ECU at work trying to get the up and running a lot of different engine's A problem I have was how to control DBW throttle body's. Over the week I have hacked together a very basic solution's using a NANO and a BTS7960 motor driver. Its a little jittery when holding at needed throttle position, need to improve that.
- test.gif (2.81 MiB) Viewed 5109 times
Re: Throttle Boddy Driver
Posted: Fri Sep 03, 2021 8:35 am
by parkview
Love the GIF! How are you driving the flap position? If it's a variable resistor, or an encoder, have you looked at the values to see if there is an instability/fluctuation in the incoming data? Maybe displaying the data in the Arduino Serial plotter might help to make sure it's linear?
Re: Throttle Boddy Driver
Posted: Tue Nov 09, 2021 7:06 pm
by rick
DBW throttle bodys have two potentiometers so I'm using one as a reface and one as current position when the positions equal each other the H bridge shuts off. I have done a lot of research since the original post. Their meant to be driven at 1000hz so i think the little nano can not keep up