ESP32 RGB LED Basic Controller

Tell us about your projects. Update us regularly.
Post Reply
parkview
Guru Maker
Posts: 522
Joined: Tue Jun 24, 2014 8:25 pm
Location: Busselton
Contact:

ESP32 RGB LED Basic Controller

Post by parkview » Mon Nov 02, 2020 12:04 pm

One of the previous projects I posted was a ESP32 RGB LED controller that included a few different sensors and it also provided control over 3 strings of plain USB powered strings of LEDs. I wanted this board to be a basic no-frills RGB LED controller. Having said that, it does have provision for a small Haptic vibrating motor port.

This board is powered from a USB micro connector and can self power up to two strings of RGB LEDs. There is a INA219A current sensor to monitor power usage, and this beta PCB version includes an OLED jumper for software development. There is no USB programming, so they can be uploaded via a serial port 1.27mm jumper. It's as small as I could make it on a 2-layer PCB, but due to the odd shape, I could not get the Panelizing software to accept the 'mouse-bites', so I ended up adding them in manually. After uploading to JLCPCB for manufacturing, I see that they have a special on for $5 for five 4 layer PCBs!

While it's not laid out concentrically, it's functional:
ESP32 Dual RGB Board.jpg
ESP32 Dual RGB Board.jpg (76.13 KiB) Viewed 523 times
and the PCB backside:
ESP32 Dual RGB Board - Back.jpg
ESP32 Dual RGB Board - Back.jpg (44.07 KiB) Viewed 523 times

Post Reply