Light Burn Camera alignment
Posted: Wed Aug 01, 2018 4:57 pm
Last week I was playing with the lightburn camera vision for work alignment.
I was using some masking tape to protect from any burn marks, which peels off leaving a nice clean surface
I was engraving some wooden coat hangers for my wifes business and the finished product
BTW The cut was not done at the settings you see on the screen level as was changed after I did the screen shot, that was my default 3mm mdf cut through
Cut/Etch circle 200mm/Sec @ 15%
Scan 200mm/Sec @ 15%
I was using some masking tape to protect from any burn marks, which peels off leaving a nice clean surface
I was engraving some wooden coat hangers for my wifes business and the finished product
BTW The cut was not done at the settings you see on the screen level as was changed after I did the screen shot, that was my default 3mm mdf cut through
Cut/Etch circle 200mm/Sec @ 15%
Scan 200mm/Sec @ 15%
- 2018-07-29_20-29-40.png (969.47 KiB) Viewed 5988 times
- IMG_0921.JPG (1.97 MiB) Viewed 5988 times
