3D Printed Bike iPhone 6S holder

Tell us about your projects. Update us regularly.
Post Reply
parkview
Guru Maker
Posts: 603
Joined: Tue Jun 24, 2014 8:25 pm
Location: Busselton
Contact:

3D Printed Bike iPhone 6S holder

Post by parkview » Tue Mar 10, 2020 1:53 pm

My iPhone 6S doesn't fit into the old 4S phone holder that I had on the bike. Not wanting to buy an updated holder for an old iPhone 6S, I decided to design up and 3D print a holder. This is the quick design I created for it:
iphone holder model.jpg
iphone holder model.jpg (23.68 KiB) Viewed 4217 times

While I designed up a top for the holder that clicks into place, I found that the iPhone fits quite firmly and will not bounce out, so the top section isn't needed. Here is the front view:
iPhone holder - top.jpg
iPhone holder - top.jpg (26.66 KiB) Viewed 4217 times

and the back view. You can see the two clip in notches in the back:
iPhone holder - front.jpg
iPhone holder - front.jpg (29.25 KiB) Viewed 4217 times

There where a couple of small improvements I have implemented, but not enough to bother printing out a replacement.

Post Reply