I magnified the photo a bit and started making measurements off the screen and created a Design Spark Mechanical drawing of it:
Here is a zoom in on the top gable:
It prints out in three sections:
- Door
- Door Frame
- Gable
I might add a 20mm wall stand off for it later.
I had some PLA based wood filament (Cherry Wood), lying around, so I thought I would print it out using that. I did a few test prints first and find that it's quite leathery feel too it. For example, the door is 56mm wide by 136.5mm high and 3.25mm thick. Pure PLA would be quite stiff, but this is can bend like a bit of tough rubber. I bet an elf couldn't bend it though
![Smile :)](./images/smilies/icon_e_smile.gif)