Prints we've tried

Post Reply
User avatar
Jubbp
Master Maker
Posts: 209
Joined: Sun Jun 22, 2014 8:15 pm
Location: Bunbury WA
Contact:

Prints we've tried

Post by Jubbp » Fri Sep 19, 2014 10:45 pm

downloaded an egg cup from thingiverse and loaded into tinker as to add the text

image.jpg
image.jpg (80.17 KiB) Viewed 1866 times

User avatar
BeJay
Maker
Posts: 139
Joined: Mon Jun 23, 2014 6:31 pm
Location: Perth
Contact:

Re: Prints we've tried

Post by BeJay » Thu Sep 25, 2014 8:02 pm

Nice!

Image

I've been busy modifying a couple of FAXLights I made for the kids to give them a bit more "Light per Wind" with some 3D printed gears. These are 2.15:1 which just fit. I haven't got a pic of the handle on this one, but it goes over the M3 bolt.

I tried using the existing brass stepper motor cog for the small end, but it stripped 3D printed cog I made in about 5 minutes of abuse! Kids are good product testers!

ps: the Daughter loves ponies.. can you tell??

These have $8 steppers from China in them that need a bit more omph than the Japanese ones on the other two I made back here that only need a 1:1 wind.

Cheers

Bj

Post Reply