Page 1 of 1
Prints we've tried
Posted: Fri Sep 19, 2014 10:45 pm
by Jubbp
downloaded an egg cup from thingiverse and loaded into tinker as to add the text
- image.jpg (80.17 KiB) Viewed 6145 times
Re: Prints we've tried
Posted: Thu Sep 25, 2014 8:02 pm
by BeJay
Nice!
I've been busy modifying a couple of FAXLights I made for the kids to give them a bit more "Light per Wind" with some 3D printed gears. These are 2.15:1 which just fit. I haven't got a pic of the handle on this one, but it goes over the M3 bolt.
I tried using the existing brass stepper motor cog for the small end, but it stripped 3D printed cog I made in about 5 minutes of abuse! Kids are good product testers!
ps: the Daughter loves ponies.. can you tell??
These have $8 steppers from China in them that need a bit more omph than the Japanese ones on the other two I made back
here that only need a 1:1 wind.
Cheers
Bj