Page 2 of 2
Re: My Felix is on the way.
Posted: Mon Jul 07, 2014 10:37 pm
by Jubbp
Thanks Paul, yes, I'm getting through the accessories, but I'm still on the learning curve so some are taking a few goes to get them acceptable.
I had to do the tweeter holder 3 times before I managed to get something worth keeping.
I assume the led bar is for a work light? I'm using a torch at the moment. Do you have yours wires into the Felix controller?
Re: My Felix is on the way.
Posted: Tue Jul 08, 2014 7:10 am
by parkview
yes, it's a 12V LED bar ~ 420mm long that I had lying around and had previously ordered from dx.com. I just run it from the 12V 3D printer PSU lines. I run mine without the switch as I have the wires coming out the wrong side.
Re: My Felix is on the way.
Posted: Tue Jul 08, 2014 1:20 pm
by seaton
Yes tweezer holder was my first print, and it gets used all the time.
LED Bar very handy especially if you're in a dark room
Re: My Felix is on the way.
Posted: Thu Jul 24, 2014 10:06 pm
by Jubbp
The Blue ebay filament has arrived and so begins the epic "Doctor Who Copyright Violation of 2014"
- IMG_2952.jpg (109.88 KiB) Viewed 10791 times
It's doing a pretty good job of printing in mid-air. I suppose I'll se when I get it off the bed in about 3 hours time.
Re: My Felix is on the way.
Posted: Tue Jul 29, 2014 3:16 pm
by seaton
haha looks like you're well and truly suckered right in now
Re: My Felix is on the way.
Posted: Tue Jul 29, 2014 10:29 pm
by Jubbp
That one turned out pretty well. I printed it at 50%. When I tried to print it at 100% I ended up with a blob of plastic wrapped around the extruder after 4 hrs of printing.