My Felix is on the way.

User avatar
Jubbp
Master Maker
Posts: 209
Joined: Sun Jun 22, 2014 8:15 pm
Location: Bunbury WA
Contact:

Re: My Felix is on the way.

Post by Jubbp » Mon Jul 07, 2014 10:37 pm

Thanks Paul, yes, I'm getting through the accessories, but I'm still on the learning curve so some are taking a few goes to get them acceptable.

I had to do the tweeter holder 3 times before I managed to get something worth keeping.

I assume the led bar is for a work light? I'm using a torch at the moment. Do you have yours wires into the Felix controller?

parkview
Guru Maker
Posts: 603
Joined: Tue Jun 24, 2014 8:25 pm
Location: Busselton
Contact:

Re: My Felix is on the way.

Post by parkview » Tue Jul 08, 2014 7:10 am

yes, it's a 12V LED bar ~ 420mm long that I had lying around and had previously ordered from dx.com. I just run it from the 12V 3D printer PSU lines. I run mine without the switch as I have the wires coming out the wrong side.

User avatar
seaton
Master Maker
Posts: 222
Joined: Tue Jun 24, 2014 11:41 am
Location: Bunbury, WA
Contact:

Re: My Felix is on the way.

Post by seaton » Tue Jul 08, 2014 1:20 pm

parkview wrote:Stephen has covered off most things.

Apart from the test prints, my first print jobs where the Felix tweezers holder: http://forum.felixprinters.com/viewtopic.php?f=9&t=97 then the spool holder kit (this is found in the Felix download section). Don't forget the LED bar as well: http://forum.felixprinters.com/viewtopic.php?f=9&t=105



Yes tweezer holder was my first print, and it gets used all the time.

LED Bar very handy especially if you're in a dark room

User avatar
Jubbp
Master Maker
Posts: 209
Joined: Sun Jun 22, 2014 8:15 pm
Location: Bunbury WA
Contact:

Re: My Felix is on the way.

Post by Jubbp » Thu Jul 24, 2014 10:06 pm

The Blue ebay filament has arrived and so begins the epic "Doctor Who Copyright Violation of 2014"

IMG_2952.jpg
IMG_2952.jpg (109.88 KiB) Viewed 15419 times


It's doing a pretty good job of printing in mid-air. I suppose I'll se when I get it off the bed in about 3 hours time.

User avatar
seaton
Master Maker
Posts: 222
Joined: Tue Jun 24, 2014 11:41 am
Location: Bunbury, WA
Contact:

Re: My Felix is on the way.

Post by seaton » Tue Jul 29, 2014 3:16 pm

haha looks like you're well and truly suckered right in now

User avatar
Jubbp
Master Maker
Posts: 209
Joined: Sun Jun 22, 2014 8:15 pm
Location: Bunbury WA
Contact:

Re: My Felix is on the way.

Post by Jubbp » Tue Jul 29, 2014 10:29 pm

That one turned out pretty well. I printed it at 50%. When I tried to print it at 100% I ended up with a blob of plastic wrapped around the extruder after 4 hrs of printing.

Post Reply