Ninjaflex
Ninjaflex
Hi I was wondering if anyone prints ninjaflex because I would like to make a timing belt for an electric skateboard and Id like to try 3d printing it. I have seen other people 3d print ninjaflex pulleys and the like so it should be possible.
I know everything about nothing.
Re: Ninjaflex
Would actually be cheaper to purchase the proper timing belt from AliExpress.com.
ninja flex can be difficult to print and doesn't have the resolution/finish of other filaments, for a timing belt you would need fairly accurrate tooth profile . If you have an STL I can take a look
ninja flex can be difficult to print and doesn't have the resolution/finish of other filaments, for a timing belt you would need fairly accurrate tooth profile . If you have an STL I can take a look
BLOG: https://my.makeraddiction.com/
Thingiverse: https://www.thingiverse.com/seaton/
Github: https://github.com/madeinoz67
Thingiverse: https://www.thingiverse.com/seaton/
Github: https://github.com/madeinoz67
Re: Ninjaflex
Yes, and timing belts usually have a mesh embedded inside the rubber to give it strength.
Re: Ninjaflex
parkview wrote:Yes, and timing belts usually have a mesh embedded inside the rubber to give it strength.
yes good point and to stop them from stretching, because then the timing will be out
BLOG: https://my.makeraddiction.com/
Thingiverse: https://www.thingiverse.com/seaton/
Github: https://github.com/madeinoz67
Thingiverse: https://www.thingiverse.com/seaton/
Github: https://github.com/madeinoz67