Universal Snap Fit Clip System
Posted: Sun Aug 14, 2016 3:32 pm
Have a laser cutter and want to be able to clip MDF/Acrylic sheets together? Stephen found this system:
https://tltl.stanford.edu/project/universal-snap-fit
I cut out a sample on a 3mm MDF today:
It feels secure and was a tight fit - which is good. I don't know how often you could repeatably remove and re-clip it though. At least the clips would be easy to cut out again if one broke.
https://tltl.stanford.edu/project/universal-snap-fit
I cut out a sample on a 3mm MDF today:
It feels secure and was a tight fit - which is good. I don't know how often you could repeatably remove and re-clip it though. At least the clips would be easy to cut out again if one broke.