Page 1 of 1
Ninjaflex
Posted: Tue Feb 23, 2016 8:59 pm
by DylanM
Hi I was wondering if anyone prints ninjaflex because I would like to make a timing belt for an electric skateboard and Id like to try 3d printing it. I have seen other people 3d print ninjaflex pulleys and the like so it should be possible.
Re: Ninjaflex
Posted: Wed Feb 24, 2016 1:21 pm
by seaton
Would actually be cheaper to purchase the proper timing belt from AliExpress.com.
ninja flex can be difficult to print and doesn't have the resolution/finish of other filaments, for a timing belt you would need fairly accurrate tooth profile . If you have an STL I can take a look
Re: Ninjaflex
Posted: Wed Feb 24, 2016 8:11 pm
by parkview
Yes, and timing belts usually have a mesh embedded inside the rubber to give it strength.
Re: Ninjaflex
Posted: Fri Feb 26, 2016 4:49 pm
by seaton
parkview wrote:Yes, and timing belts usually have a mesh embedded inside the rubber to give it strength.
yes good point and to stop them from stretching, because then the timing will be out